IT資格問題集の試験範囲を徹底分析&網羅! 問題集売上No.1

ktestの試験問題集で何らかの理由で資格取得が必要な方に、最短パスをお伝えします。

KtestのCisco 352-001試験過去問はあなたが一回で試験に合格するのを助けることができます

多くのCCDE資格の352-001試験過去問を準備している受験生がいろいろなCisco Certified Design Expert Qualification Exam技術試験についてサービスを提供するサイトオンラインがみつけたがKtestはIT業界トップの専門家が研究した参考材料で権威性が高く、品質の高い教育資料で、一回に参加する受験者も合格するのを確保いたします。


試験コード: 352-001 CCDE
関連資格: CCDE
試験時間: 120 minutes (90 - 110 questions)
試験言語: English
試験登録: Pearson VUE
352-001動画講座:https://youtu.be/s9U4x-3-U20

Ktestは最新の352-001試験過去問を提供します。Ktestの352-001試験過去問はあなたが一回で試験に合格するのを助けることができます。Ktestは最新の352-001試験過去問と高品質の問題と回答を提供します。Ktestの352-001試験過去問はあなたが一回で試験に合格するのを助けることができます。高品質の352-001試験過去問は、あなたがより迅速かつ簡単に試験に合格することを100%保証します。Cisco Certified Design Expert Qualification Exam試験に合格して認証資格を取るのはそのような簡単なことです。

下記は352-001試験過去問デもをご参考ください。

1.You are designing the QoS features for a large enterprise network that includes DMVPN.
When would you need to configure QoS preclassify?
A. when you are marking packets with the DSCP bits
B. when you are marking packets with the TOS bits
C. when your service provider requires the DSCP bits be set
D. when the QoS policy cannot be based on DSCP ToS bits
Answer: D

2.A company wants to use SSM as the multicast routing protocol inside its network. Some of its multicast
applications do not support IGMPv3.
In which two ways can the mapping be done when these applications send IGMPv2 join messages?
(Choose two.)
A. The Layer 2 switches can send a request to a DNS server.
B. The Layer 3 multicast routers can send a request to a DNS server.
C. The mapping can be done statically at the Layer 2 switches.
D. The mapping can be done statically at the Layer 3 multicast routers.
E. The Layer 2 switches can transform the IGMPv2 join to an IGMPv3lite join.
F. The Layer 3 multicast routers can transform the IGMPv2 join to an IGMPv3lite join.
Answer: B,D

3.You are working on a network design plan for a company with approximately 2000 sites. The sites will
be connected using the public Internet. You plan to use private IP addressing in the network design, which
will be routed without NAT through an encrypted WAN network. Some sites will be connected to the
Internet with dynamic public IP addresses, and these addresses may change occasionally.
Which VPN solution will support these design requirements?
A. GET VPN must be used, because DMVPN does not scale to 2000 sites.
B. DMVPN must be used, because GET VPN does not scale to 2000 sites.
C. GET VPN must be used, because private IP addresses cannot be transferred with DMVPN through the
public Internet.
D. DMVPN must be used, because private IP addresses cannot be transferred with GET VPN through the
public Internet.
E. GET VPN must be used, because DMVPN does not support dynamic IP addresses for some sites.
F. DMVPN must be used, because GET VPN does not support dynamic IP addresses for some sites.
Answer: D

4.When you design a network, when would it be required to leak routes into a Level 1 area?
A. when a multicast RP is configured in the nonbackbone area
B. when MPLS L3VPN PE devices are configured in the Level 1 areas
C. when equal cost load balancing is required between the backbone and nonbackbone areas
D. when unequal cost load balancing is required between the backbone and nonbackbone areas
Answer: B